Wireless Access

Reply
Regular Contributor I
Posts: 179
Registered: ‎08-29-2008

Controller Boot Error

I have a backup controller that displays the following error during boot up...

 

CPBoot 1.2.0.0 (build 20527)
Built: 2009-01-20 at 18:55:40
DRAM:  Operating at 533 MHz
DRAM:  Channel 0: 1024 MB

Unable to locate a working CMD and/or SLV_CMD strobe configuration for this channel.

 

The controller lost power before this problem started, does this mean the memory is fried or is there something I can do to get past this point?

 

Thanks

 

Guru Elite
Posts: 20,821
Registered: ‎03-29-2007

Re: Controller Boot Error


WorlisMan wrote:

I have a backup controller that displays the following error during boot up...

 

CPBoot 1.2.0.0 (build 20527)
Built: 2009-01-20 at 18:55:40
DRAM:  Operating at 533 MHz
DRAM:  Channel 0: 1024 MB

Unable to locate a working CMD and/or SLV_CMD strobe configuration for this channel.

 

The controller lost power before this problem started, does this mean the memory is fried or is there something I can do to get past this point?

 

Thanks

 


Certainly not user serviceable.  Please call support.



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor I
Posts: 9
Registered: ‎06-11-2015

Re: Controller Boot Error

I encounter the same error.

But fixed by swapping the RAM to each other slot

Search Airheads
Showing results for 
Search instead for 
Did you mean: