I just installed 6 new VLANS on my 7220 controller. The VLAN status is "ADMIN UP" "OPERATIONAL STATE DOWN". How do I turn up the operational state?
They would either:
(1) Need to be attached to a physical interface that is up or:
(2) have a user in that vlan.
Alternatively you can do this:
config t
interface vlan x
operstate up
I have a similar isssue but in my case i have the controller managed by a mobility master hence i will not be able to make any changes, so how do i proceed in this case to enable the oper status Up
© Copyright 2024 Hewlett Packard Enterprise Development LPAll Rights Reserved.