@cdj wrote:
I miss spoke, I currently have 3.4.2.2 and 3.4.5.1 on partition 0 and 1 respectfully. The problem is after I following the steps in the document, it still seems to pull from the default.cfg even after the " boot config-file <newstartup-config> command. Also when I do a show boot, it show the config file I want but it just does run that config.
Does this solution only apply if you have 3.3.1.x on one of the partitions?
The boot config-file parameter is case sensitive. If you point to a file that does not exist, it will boot from the default.cfg file. If you also manipulate a configuration file offline, you could also get the error that you mention as well as that result. To make sure, please open a case with support so that they get to the bottom of your issue.