Wireless Access

Reply

Dynamic server selection rule stops working after power outage

I have setup for a customer some dynamic server selection rules based on 'match auth-string contains'.  This is working fine, however after a power outage, things stopped working and the corp device were falling through to the default server that resulted in putting them into the mobile-device role.

 

I am able to quickly recover by removing the rule, then putting it back in exactly the same, and the corp users are sent to the server they should be, and get the correct role.

 

This same issue was seen when we upgraded from 6.2 to 6.3.1.10.  Once again, the fix was the same.

 

Has anyone else seen this particular issue?

 

Hardware - 3200XM

AOS - 6.3.1.10


If my post is helpful please give kudos, or mark as solved if it answers your post.

ACCP, ACMP, ACMX #294
mclarke@arubanetworks.com
Guru Elite

Re: Dynamic server selection rule stops working after power outage

Michael_Clarke,

 

Hopefully you have the logs.tar from when it was not working so that a case can be opened..



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Re: Dynamic server selection rule stops working after power outage

yes, already submitted to TAC.


If my post is helpful please give kudos, or mark as solved if it answers your post.

ACCP, ACMP, ACMX #294
mclarke@arubanetworks.com
Guru Elite

Re: Dynamic server selection rule stops working after power outage

Michael_Clarke, Thank you.

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Re: Dynamic server selection rule stops working after power outage

regrettably there was insufficient information in the logs.


If my post is helpful please give kudos, or mark as solved if it answers your post.

ACCP, ACMP, ACMX #294
mclarke@arubanetworks.com
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: