Wireless Access

Reply
Contributor I
Posts: 68
Registered: ‎07-16-2012

Enable Centralised Licensing

Just wanted to clarify;

 

Two Controllers running 6.3.1.6. 

 

Setup is Master/Standby via VRRP.

 

All I need to do is enter my VRRP address into the License Server IP field and tick the enable box and save. All done on the Master controller.

 

I assume this will not be service disruptive?

Guru Elite
Posts: 8,793
Registered: ‎09-08-2010

Re: Enable Centralised Licensing

Yes, and then point your local controllers to the VRRP address under the
central licensing configuration.

Tim Cappalli | Aruba Security TME
@timcappalli | timcappalli.me | ACMX #367 / ACCX #480
Contributor I
Posts: 68
Registered: ‎07-16-2012

Re: Enable Centralised Licensing

Thank you :)

 

FYI we're not running any local controllers. just the two, master and standby/master

Contributor I
Posts: 68
Registered: ‎07-16-2012

Re: Enable Centralised Licensing

[ Edited ]

Hmm seems you need to enable the function on the standby controller also.

 

Looks all ok however the VRRP address wont take in the License Server IP field. I assume in this config then it isnt needed as the standby will just take them anyway should it become the Master?

 

The VRRP address is 192.168.64.250 FYI

 

See screenies attached.

Guru Elite
Posts: 8,793
Registered: ‎09-08-2010

Re: Enable Centralised Licensing

[ Edited ]

Sorry, I misread your question. Central licensing needs to be enabled on each controller. 

 

On the master and master/backup, simply check the enable central licensing and license redundancy checkbox. If you are already using master redundancy, you don't need to configure the VRRP info.

 

Leave the license server IP blank.

 


Tim Cappalli | Aruba Security TME
@timcappalli | timcappalli.me | ACMX #367 / ACCX #480
Search Airheads
Showing results for 
Search instead for 
Did you mean: