Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Getting an error while configuring 204 model ap

This thread has been viewed 1 times

  • 1.  Getting an error while configuring 204 model ap

    Posted May 30, 2016 11:53 AM

    Hi all,

     

    i am tring to configure an 204 AP from CLI, but getting error message like below. please help any one..

     

    Fyi, now i have connnected this AP to the switchport without antena and doing configuration..

     

    conf t

    provision-ap
    read-bootinfo ap-name <apname>
    ap-group <ap-group>
    ap-name ap-name
    Antenna gain not provisioned for band 802.11a  ------>  Error message,, wht iam getting...

     

    Any one can please help..

     

    Thnks,

    Raja



  • 2.  RE: Getting an error while configuring 204 model ap
    Best Answer

    EMPLOYEE
    Posted May 31, 2016 01:12 AM

    Why are you provisioning this AP using the CLI instead of the GUI?

     



  • 3.  RE: Getting an error while configuring 204 model ap

    Posted May 31, 2016 07:50 AM

    Thanks for reply Joseph.

     

    Yes, i have configured the AP using GUI and now its back to normal. So, what are the standardard/recomanded values for 5/2.4 GHz Antenna Gain (dBi) values for better performance.

     

    Thanks,

    Raja



  • 4.  RE: Getting an error while configuring 204 model ap
    Best Answer

    EMPLOYEE
    Posted May 31, 2016 08:13 AM

    The values you enter there should be based on the antenna that is actually connected, for optimal performance. If entered incorrectly, the radio power values will not be accurate.



  • 5.  RE: Getting an error while configuring 204 model ap
    Best Answer

    Posted May 31, 2016 08:26 AM

    ok understand.. thanks jerrod.

     

    i will check the antenna and give the proper values.. thnks..