Wireless Access

Reply
Occasional Contributor II
Posts: 13
Registered: ‎06-23-2014

Getting an error while configuring 204 model ap

Hi all,

 

i am tring to configure an 204 AP from CLI, but getting error message like below. please help any one..

 

Fyi, now i have connnected this AP to the switchport without antena and doing configuration..

 

conf t

provision-ap
read-bootinfo ap-name <apname>
ap-group <ap-group>
ap-name ap-name
Antenna gain not provisioned for band 802.11a  ------>  Error message,, wht iam getting...

 

Any one can please help..

 

Thnks,

Raja

Guru Elite
Posts: 21,022
Registered: ‎03-29-2007

Re: Getting an error while configuring 204 model ap

Why are you provisioning this AP using the CLI instead of the GUI?

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor II
Posts: 13
Registered: ‎06-23-2014

Re: Getting an error while configuring 204 model ap

Thanks for reply Joseph.

 

Yes, i have configured the AP using GUI and now its back to normal. So, what are the standardard/recomanded values for 5/2.4 GHz Antenna Gain (dBi) values for better performance.

 

Thanks,

Raja

MVP
Posts: 1,310
Registered: ‎11-07-2008

Re: Getting an error while configuring 204 model ap

The values you enter there should be based on the antenna that is actually connected, for optimal performance. If entered incorrectly, the radio power values will not be accurate.

Jerrod Howard
Sr. Techical Marketing Engineer
Occasional Contributor II
Posts: 13
Registered: ‎06-23-2014

Re: Getting an error while configuring 204 model ap

ok understand.. thanks jerrod.

 

i will check the antenna and give the proper values.. thnks..

Search Airheads
Showing results for 
Search instead for 
Did you mean: