Wireless Access

Reply
Contributor I
Posts: 21
Registered: ‎02-26-2016

HA Role DUAL - only seeing APs on one controller

I have my controllers set up using HA Role DUAL -  acording to the documentation half the clients should connect to each contoller, however when i look on my controllers all clients are associated to one controller.

 

Am i reading outdated documentation? I'm running 6.4.3

Guru Elite
Posts: 21,280
Registered: ‎03-29-2007

Re: HA Role DUAL - only seeing APs on one controller

Dual means that controllers can be active for standby. It does not mean load balancing.


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Contributor I
Posts: 21
Registered: ‎02-26-2016

Re: HA Role DUAL - only seeing APs on one controller

Although configured as dual, It looks more like its doing a active/standby config, althought the docs say each should be terminating 1/2 the clients?

 

http://www.arubanetworks.com/techdocs/ArubaOS_63_Web_Help/Content/ArubaFrameStyles/VRRP/HighAvFastFailover.htm

 

http://www.arubanetworks.com/techdocs/ArubaOS_64_Web_Help/Content/ArubaFrameStyles/VRRP/HighAvFastFailover.htm

MVP
Posts: 4,301
Registered: ‎07-20-2011

Re: HA Role DUAL - only seeing APs on one controller

The distribution of the APs depends on the LMS IP configured on the AP-Sys profile/AP-GROUP .



Sent from Outlook for iPhone
Thank you

Victor Fabian
Lead Mobility Engineer @ Integration Partners
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA
Search Airheads
Showing results for 
Search instead for 
Did you mean: