Wireless Access

Reply
New Contributor
Posts: 4
Registered: ‎10-28-2013

How i can disable the transmit signal from a specified AP-105 on a Aruba Controller

Hi all
we works with Aruba contr. 6000 Softw. 6.1.3.10
For test in a specified room we have to disable the completely RF  signal for  any specified Accesspoints AP-105. pls. can anybody tell me i can do that with a cli command.
Thanks  in advanced
regards Roland

Guru Elite
Posts: 21,010
Registered: ‎03-29-2007

Re: How i can disable the transmit signal from a specified AP-105 on a Aruba Controller

You should use an ap-specific configuration.  Please see the article here:  http://community.arubanetworks.com/t5/Campus-Switching-and-Routing/how-to-assign-a-arm-profile-to-a-specific-ap-in-gui-and-cli/m-p/278190  Under ap-specific for that AP, you would just go under RF> Radio Profile and create a radio profile that has the radio "off" and assign it to that AP.

 

When you are done with it, you can just delete the ap-specific configuration and the AP will just use the configuration from the ap-group.



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

New Contributor
Posts: 4
Registered: ‎10-28-2013

Re: How i can disable the transmit signal from a specified AP-105 on a Aruba Controller

Hi Colin
Thanks for solution :-)

 

Cheers Roland

 

Search Airheads
Showing results for 
Search instead for 
Did you mean: