Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Expand all | Collapse all

How setup Microsoft VPN client on a Aruba controller.

This thread has been viewed 1 times
  • 1.  How setup Microsoft VPN client on a Aruba controller.

    Posted Jun 06, 2012 04:04 PM

    Hi,

     

    I can connect my laptop with Microsoft VPN client on my Aruba controller with RADIUS authentication.

    My laptop take an IP address in the VPN address pool and he can ping the controller IP interfaces.

    My laptop take also the role default-vpn-role.

    The problem is "I think" routing, because the laptop ping the controller but nothing else. He don't have any access in the internal network. He was alone in the RAP address pool.

    I tried to modify default-vpn-role role with allowall or scrnat policies but I see no change.

    Any idea ?



  • 2.  RE: How setup Microsoft VPN client on a Aruba controller.

    EMPLOYEE
    Posted Jun 06, 2012 04:25 PM

    In that case, the default-vpn-role should have:

     

    any any dhcp permit

    any any any src-nat

     

    The only way around this is if your VPN pool is giving out addresses in a subnet that is routable and contains an ip interface on the controller.



  • 3.  RE: How setup Microsoft VPN client on a Aruba controller.

    Posted Jun 11, 2012 09:55 AM

    I opened an Aruba case for that because it's always the same result if I scrnat or not.
    Thanks for the answer.

    I will update this issue later.



  • 4.  RE: How setup Microsoft VPN client on a Aruba controller.

    Posted Oct 19, 2012 10:27 AM

    sorry for the delay

     

    My problem was only because the Inter VLAN routing was not enable between my two networks.

     

    Thanks.