Wireless Access

Reply
New Contributor
Posts: 3
Registered: ‎08-03-2009

How setup Microsoft VPN client on a Aruba controller.

Hi,

 

I can connect my laptop with Microsoft VPN client on my Aruba controller with RADIUS authentication.

My laptop take an IP address in the VPN address pool and he can ping the controller IP interfaces.

My laptop take also the role default-vpn-role.

The problem is "I think" routing, because the laptop ping the controller but nothing else. He don't have any access in the internal network. He was alone in the RAP address pool.

I tried to modify default-vpn-role role with allowall or scrnat policies but I see no change.

Any idea ?

Guru Elite
Posts: 20,764
Registered: ‎03-29-2007

Re: How setup Microsoft VPN client on a Aruba controller.

[ Edited ]

In that case, the default-vpn-role should have:

 

any any dhcp permit

any any any src-nat

 

The only way around this is if your VPN pool is giving out addresses in a subnet that is routable and contains an ip interface on the controller.



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

New Contributor
Posts: 3
Registered: ‎08-03-2009

Re: How setup Microsoft VPN client on a Aruba controller.

I opened an Aruba case for that because it's always the same result if I scrnat or not.
Thanks for the answer.

I will update this issue later.

New Contributor
Posts: 3
Registered: ‎08-03-2009

Re: How setup Microsoft VPN client on a Aruba controller.

sorry for the delay

 

My problem was only because the Inter VLAN routing was not enable between my two networks.

 

Thanks.

Search Airheads
Showing results for 
Search instead for 
Did you mean: