Wireless Access

Reply
MVP
Posts: 1,434
Registered: ‎10-25-2011

How to add non-valid APs as Valid in the controller or though Airwave

[ Edited ]

The scenario is as follows:

 

Some new APs will be introduced (non-aruba) and I need to make them valid APs so they do not get recognized as Rogues.

Campus Deployment


I have the MAC addresses but these APs have not been introduced to the network yet.

 

Can I do this?

Can I them to the campus whitelist?

is there a CLI command I can run something like "wms ap <bssid> mode valid"???

EDIT: The same applies to specific client MAC

Can I do 'wms client <mac> mode valid" ??

Pasquale Monardo | Senior Network Solutions Consultant
ACDX #420 | ACMP
[If you found my post helpful, please give kudos!]
MVP
Posts: 1,434
Registered: ‎10-25-2011

Re: How to add non-valid APs as Valid in the controller or though Airwave

What I ended up doing was the following:

 

wms client <mac> mode valid

and

wms ap <bssid> mode valid

 

Whether it worked or not, I am not sure but I know for sure that it worked on an AP that was in the show wms ap list output.

 

I am assuming that once the AP gets detected wirelessly that it will be set to valid.

 

Pasquale Monardo | Senior Network Solutions Consultant
ACDX #420 | ACMP
[If you found my post helpful, please give kudos!]
Search Airheads
Showing results for 
Search instead for 
Did you mean: