Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
How to enable SNMP AP225,224
How to enable SNMP AP225,224
09-04-2014 02:12 AM - edited 09-04-2014 02:16 AM
For PRTG Network Monitor Thank...
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Alert a Moderator
Re: How to enable SNMP AP225,224
Re: How to enable SNMP AP225,224
09-10-2014 06:23 PM
your screenshot shows that you have enabled snmp and enabled snmp-traps to be sent to 2 different places. This is from the controller side, you configure PRTG to monitor the controller. APs are thin APs, therefore you cannot monitor them directly unless you use Airwave or build your own way to SNMP walk the controller to get AP status.
You've also posted in the wrong forum, please post controller/snmp/ap questions in the Unified Wired/Wireless sub-forum
You've also posted in the wrong forum, please post controller/snmp/ap questions in the Unified Wired/Wireless sub-forum
Pasquale Monardo | Senior Network Solutions Consultant
ACDX #420 | ACCA
[If you found my post helpful, please give kudos!]
ACDX #420 | ACCA
[If you found my post helpful, please give kudos!]
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Alert a Moderator