Wireless Access

Reply
New Contributor
Posts: 2
Registered: ‎02-06-2012

How to reload Aruba 651 internal AP to defaults

[ Edited ]

Hello!

I had problems with discovering APs with Aruba 651, after resetting to factory defaults (connecting with console) external APs (AP 65 and Ap 120) are visible and working. Question is about internal AP of AR 651 - I don't know how to connect to it CLI, because only console port availiable is port of the controller and so I couldn't reset AP to factory defaults. What is possible solution ? ArubaOS version is 6.1.2.2

Guru Elite
Posts: 21,513
Registered: ‎03-29-2007

Re: How to reload Aruba 651 internal AP to defaults

You would have to reprovision it like any other AP.  There is nothing to recover with the console.  Just reprovision him to change his ap-name and ap-group.  This will require a reboot of the controller, however.

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

New Contributor
Posts: 2
Registered: ‎02-06-2012

Re: How to reload Aruba 651 internal AP to defaults

I don't see any APs in the section AP installation. How can i reprovision it when it says "none found" ? Just reloaded to factory defaults, still nothing.

Guru Elite
Posts: 21,513
Registered: ‎03-29-2007

Re: How to reload Aruba 651 internal AP to defaults

If it does not show up at all in the controller, please open a support case.


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: