Wireless Access

Reply
Highlighted
New Contributor
Posts: 1
Registered: ‎12-24-2014

I am unable to create a vlan pool by either cli or gui. What should I do?

I have 4 3400 controllers running 6.3 and I am unable to create a vlan pool on my slave controllers.  My Master works fine but it will not allow creation on the slaves.  Any ideas?

 

Thanks,

Guru Elite
Posts: 8,191
Registered: ‎09-08-2010

Re: I am unable to create a vlan pool by either cli or gui. What should I do?

The vlan pools are created on the master and get pushed down to the locals when you save config. The only piece you would do on the local is map VLAN IDs to the the pool.

Tim Cappalli | Aruba ClearPass TME
@timcappalli | ACMX #367 / ACCX #480 / ACEAP / CWSP
MVP
Posts: 329
Registered: ‎04-25-2013

Re: I am unable to create a vlan pool by either cli or gui. What should I do?

the vlan pools can be created in the master  controller only , but you should map vlans ID to those vlan pools from local controllers

Raouf CHAHBOUNE
ICT Network & Security Engineer
CCNP R/S | CCNA Security | ACMP|ACDX



[If my post is helpful please give kudos, or mark as solved if it answers your post.]
Search Airheads
Showing results for 
Search instead for 
Did you mean: