Wireless Access

Reply
Occasional Contributor II
Posts: 15
Registered: ‎09-29-2010

I have a question on VisualRF.

I have a floor map of a 5 story building and I am trying to run a report that reflects the speed. So I right click on the biulding and and click Show Bill of Materials. I sellect heat maps and Speed. when the report comes up it only shows 300Mbs for the highest speed on the floor map. the customer needs to see the projected speed at least 850Mbps. I would like to run it at the 1.3Gbps Rate so the customer can see it.

 

How can i change the speed rate that shows on the report?

 

 

Contributor I
Posts: 22
Registered: ‎04-02-2013

Re: I have a question on VisualRF.

Wizard I'm interested on which platform are you getting this from, AirWave or the Mobility Controller?

Guru Elite
Posts: 20,761
Registered: ‎03-29-2007

Re: I have a question on VisualRF.


Wizard wrote:

I have a floor map of a 5 story building and I am trying to run a report that reflects the speed. So I right click on the biulding and and click Show Bill of Materials. I sellect heat maps and Speed. when the report comes up it only shows 300Mbs for the highest speed on the floor map. the customer needs to see the projected speed at least 850Mbps. I would like to run it at the 1.3Gbps Rate so the customer can see it.

 

How can i change the speed rate that shows on the report?

 

 


Do you have AP225s on the map?  I am not even sure if anything can be modeled at over 300.  Those speeds require that the client have special capabilities and be 5 feet from the access point.  In short, it probably cannot be done and it is not practical.

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: