06-22-2014 01:41 PM
as I'm new to aruba I was deploying Master-master standby and one local deployment everything went fine except one thing
on the local controller I create Vlan 40 with IP 192.168.40.40 and I used it as teh controller IP and on all controllers I didn't create loobacks as I didn't understand in what may I need it and the strange thing is I type :
on interface gig 1/1 I typed:
switchport access vlan 40
switch port mode access
and on interface gig 1/2
I typed :
switchport mode trunk
switch trunk allown VLAN all
switch trunk vlan native 40
now I connect nortel switch on each port in vlan 40 and my laptop in vlan 40 but it didn't ping at all it just a basic network config but t didn't ping
notes:all ports are trusted.
I used another Vlan for master local connectivity and it worked fine.
now why it didn't ping which it just a normal setting?
06-22-2014 02:45 PM
Make sure that the native vlan on the Nortel side is also 40.
Aruba Customer Engineering
Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base