01-27-2015 06:10 AM
i have IAP 103 can not join on 3200 Controller, the IAP and Controller in the same VLAN
IAP get IP from DHCP but can't find the Controller, tried to activate the DHCP server on the Conrtoller itself , IAP got the IP normally but still can't join
i checking it by AP installation under Wireless tap
Controller Version 184.108.40.206
IAP version 220.127.116.11-18.104.22.168_44004
- I added an entry in DHCP server for Conntroller IP mapping to aruba-master. but still the IAP can't join
- added the IP of the Conntorller on the IAP manually but with no success also
- IAP Auto join mode : enable
- Conntroller discovery mode:enable
map Controller IP
01-27-2015 06:42 AM - edited 01-27-2015 06:50 AM
actually i dont know, cause we just received that IAP 103 with 3200 Controller for LAP prupose
do i need to convert it from Maintenancetab in the IAP 103 ?
and how i can know it's in Stand alone or Controler mode ?
01-27-2015 06:51 AM
01-27-2015 07:03 AM
but i just read that frol 6.4 release not
ArubaOS 6.4 is supported only on the newer MIPS controllers (7200 Series, M3, 3200XM, 3400, 3600, and 600
Series). Legacy PPC controllers (200, 800, 2400, SC1/SC2) and 3200 controllers are not supported. Do not
upgrade to ArubaOS 6.4 if your deployment contains a mix of MIPS and PPC controllers in a master-local setup
do you think i can upgrade ?
01-27-2015 07:05 AM
01-27-2015 07:22 AM
may you are right.
ruba Operating System Software.
ArubaOS (MODEL: Aruba3200), Version 22.214.171.124
Copyright (c) 2002-2014, Aruba Networks, Inc.
Compiled on 2014-04-08 at 20:23:43 PDT (build 43118) by p4build
ROM: System Bootstrap, Version CPBoot 126.96.36.199 (build 35189)
Built: 2012-09-06 16:05:33
Built by: p4build@re_client_35189
Switch uptime is 5 hours 44 minutes 29 seconds
Reboot Cause: User reboot (Intent:cause:register 78:86:50)
Processor XLR 508 (revision C4) with 1187M bytes of memory.
32K bytes of non-volatile configuration memory.
512M bytes of Supervisor Card System flash (model=CF 512MB)