Wireless Access

Reply
Occasional Contributor II

Instant 8.3.0.0 Mesh disabled

Hi! Im having problems setting up mesh in Instant 8.3.0.0. My setup works fine in 6.5.4.6, but upgrading to 8.3.0.0 gives me the "No mesh supported in current mode" when running Show ap mesh link. Running the same config, and downgrading to 6.5 fixes the issue.


I have looked in the user guide for 8.3.0.0. but i can't find any new settings required to enable mesh in 8.x software.

Anyone know what is up?

Guru Elite

Re: Instant 8.3.0.0 Mesh disabled

What model access points are those?

*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.3 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Occasional Contributor II

Re: Instant 8.3.0.0 Mesh disabled

IAP-225, IAP215 and IAP 303H are present in the cluster. IAP-215 is my current Mesh Point.

Guru Elite

Re: Instant 8.3.0.0 Mesh disabled

The IAP-303H does not support mesh, so that might be why you got that message.


*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.3 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Occasional Contributor II

Re: Instant 8.3.0.0 Mesh disabled

That i did not know. Thank you.

Guru Elite

Re: Instant 8.3.0.0 Mesh disabled

I got that from the ArubaOS 8.3.0.0 release notes:

Screenshot 2018-06-28 at 08.39.15.png

 

The other access points say that they support mesh.


*Answers and views expressed by me on this forum are my own and not necessarily the position of Aruba Networks or Hewlett Packard Enterprise.*
ArubaOS 8.3 User Guide
InstantOS 8.3 User Guide
Airheads Knowledgebase
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: