Wireless Access

last person joined: 22 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Leap query

This thread has been viewed 0 times

  • 1.  Leap query

    Posted Jun 24, 2015 12:31 PM

    Hello,

     

    In our environment we operate a 'master / master-standby' model. We are looking to disable the NTP services on the controllers in recognition of the leap second later this month. We have had no issue configuring this on the master, but are unable to remove the configuration from the standby? The 'no ntp server' command isn't an option in the CLI, yet the 'show ntp status' reveals the controller is still communicating with the NTP server.

     

    Any advice on this please?

     

    Thanks



  • 2.  RE: Leap query

    Posted Jun 24, 2015 12:42 PM


  • 3.  RE: Leap query

    Posted Jun 24, 2015 12:47 PM
      |   view attached

    Interestingly, in the GUI the NTP entries are there, but the options to delete are greyed out.



  • 4.  RE: Leap query

    Posted Jun 24, 2015 12:48 PM

    Using 6.4.2.5



  • 5.  RE: Leap query

    EMPLOYEE
    Posted Jun 24, 2015 01:13 PM

    You need to be on the active master to delete the NTP servers...



  • 6.  RE: Leap query

    Posted Jun 24, 2015 01:33 PM
      |   view attached

    Thanks cjoseph,

     

    I've done this on the active master with the 'no ntp server' command. However, when I review the NTP status on the secondary they still show as connected to the NTP peer?

     

    Is there a command on the master to remove them from the secondary?

     

     

     

     



  • 7.  RE: Leap query

    EMPLOYEE
    Posted Jun 24, 2015 01:36 PM
    Do a write mem or save configuration on the master so that the config is pushed.


  • 8.  RE: Leap query

    Posted Jun 24, 2015 01:39 PM

    Doh, that'll do it, thanks...