Wireless Access

Reply
MVP
Posts: 1,011
Registered: ‎04-13-2009

Lync SDN API Setting

Hi,


I'm configuring the Lync ALG as per the 6.3.1 user guide, didn't encounter any issues. I just need to install and setup the Lync SDN API.


Is the server URI on the Lync SDN API wizard the controller IP/DNS name?

 

E.g. http://aruba-master/

 

or http://aruba-master/something

 

lync sdn api.JPG

 

Thanks

James

Cheers
James

-------------------------------------------------------
-------------------@whereisjrw-------------------
------------------------blog-------------------------
ACCX #540 | ACMX #353 | ACDX #216
-----------Mobility First Expert #11----------
-------------------------------------------------------

If a reply adequately addresses your issue, please click on the "Accept as Solution" and "Give Kudos" button so this information can benefit other users via search.
MVP
Posts: 1,011
Registered: ‎04-13-2009

Re: Lync SDN API Setting

Or rather http://aruba-master:8181,https://aruba-master:8282

 

(assuming that those are the ports configured on the controller for Lync HTTP and HTTPS listening ports)

Cheers
James

-------------------------------------------------------
-------------------@whereisjrw-------------------
------------------------blog-------------------------
ACCX #540 | ACMX #353 | ACDX #216
-----------Mobility First Expert #11----------
-------------------------------------------------------

If a reply adequately addresses your issue, please click on the "Accept as Solution" and "Give Kudos" button so this information can benefit other users via search.
Guru Elite
Posts: 21,587
Registered: ‎03-29-2007

Re: Lync SDN API Setting

[ Edited ]

http://controller-ip-address:<port>



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

MVP
Posts: 1,011
Registered: ‎04-13-2009

Re: Lync SDN API Setting

Thanks Colin.

Cheers
James

-------------------------------------------------------
-------------------@whereisjrw-------------------
------------------------blog-------------------------
ACCX #540 | ACMX #353 | ACDX #216
-----------Mobility First Expert #11----------
-------------------------------------------------------

If a reply adequately addresses your issue, please click on the "Accept as Solution" and "Give Kudos" button so this information can benefit other users via search.
Aruba Employee
Posts: 64
Registered: ‎04-07-2007

Re: Lync SDN API Setting

HI James-

 

Actually there is a bit more to set up. We are just about to release the config guide for the Lync SDN API. I will DM you with the pre-release version. 

 

In short you need to configure the lync web listener port in the web-server section. If you are going to use https you need to make sure you have trusted certs on the lync and aruba controller. For http you can use IP for https you MUST use an FQDN. The guide goes through that as well. 

 

Then you need to modify the LyncDialogListener.exe.config file after the install to send the controller the right values.

 

<?xml version=”1.0” encoding=”utf-8”?> <configuration>

<appSettings>
<add key=”submituri” value=”

http://10.10.110.1:15790;https://aruba-lync.arubanetworks.com:15790

“/><add key=”hidepii” value=”false”/>
<add key=”sendallcallqoe” value=”true”/> <add key=”sendrawsdp” value=”false”/>
<add key=”sendcallinvites” value=”false”/> 

 

Finally you need to ensure that classify media is turned off on the ACL used to detect Lync traffic. 

 

John

Search Airheads
Showing results for 
Search instead for 
Did you mean: