Wireless Access

last person joined: 10 hours ago 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Master-Backup - Unable to add localip

This thread has been viewed 0 times

  • 1.  Master-Backup - Unable to add localip

    MVP EXPERT
    Posted Nov 27, 2015 12:48 PM

     

     Hi all, I was wondering if you could help with the following. We have an Master - Master Backup deployment with a local controller which points to the VRRP address on the Master controllers.

    However in the event of a failover to the back master, I don’t think the local controller will be able to connect to the backup-master since this parameter is not in there.

    Basically don’t seem to have the option to add a localip to the backup-master.  Not sure if that is expected behaviour. ?

     
    Current version is Aruba OS 6.4.2.5



  • 2.  RE: Master-Backup - Unable to add localip

    EMPLOYEE
    Posted Nov 27, 2015 01:12 PM
    The localip parameter on the master or the local?


  • 3.  RE: Master-Backup - Unable to add localip

    MVP EXPERT
    Posted Nov 28, 2015 03:06 AM

    Hey on the backup master. Thanks



  • 4.  RE: Master-Backup - Unable to add localip

    EMPLOYEE
    Posted Nov 28, 2015 04:07 AM

    Do you have a screenshot of that?   On every master controller, you should be able to configure the localip for each local controller that would connect:

    (host) (config) #localip 0.0.0.0 ipsec gw1234xyz

     

    On every local controller, you should be able to configure the master controller that the local controller would connect to:

    (host) (config) #masterip 10.1.1.250 ipsec gw1234567

    Are you saying that the localip command is not available on the backup master?  It should be...