Hi all,
just on the same issue ,i`m new to aruba`s world ,we have a master controller (192.168.1.148)that`s running fine and i need to set up a local controller(192.168.1.149) and configure redundancy .the problem is that i don`t know the ipsec preshared key that is configured on the master controller . i tried to use encrypt disable but i didn`t know where to look on the running config :
i have the below config on the master :
Crypto Map "default-psk-redundant-master-ipsecmap" 9999 ipsec-isakmp
Crypto Map Template"default-psk-redundant-master-ipsecmap" 9999
IKE Version: 1
IKEv1 Policy: All
Security association lifetime seconds : [300 -86400]
Security association lifetime kilobytes: N/A
PFS (Y/N): N
Transform sets={ default-ml-transform }
Peer gateway: 192.168.1.149
Interface: VLAN 0
Source network: 192.168.1.148/255.255.255.255
Destination network: 192.168.1.149/255.255.255.255
Pre-Connect (Y/N): Y
Tunnel Trusted (Y/N): Y
Forced NAT-T (Y/N): N
Uplink Failover (Y/N): N
Force-Tunnel-Mode (Y/N): N
IP Compression (Y/N): N
how can i get the preshared key from the master ? if i need to use `encrypt enable `which part of the config i need to look to ?thank you in advance