09-20-2013 08:17 AM
Really technical issue here!!!
I can't seem to find a copy of the RAP-2WG zero touch instructions. Can anyone point me in the right direction?
Thanks so much
Solved! Go to Solution.
09-20-2013 08:27 AM
Is this what you are looking for?
09-20-2013 04:40 PM
Zero-Touch configuration using Aruba Activate and AirWave is not supported on the RAP-2 or RAP-5. It is supported on all IAPs and the new RAPs (RAP-3, RAP-10x, RAP-155).
For the RAP-2 and RAP-5 either you pre-provision them or the end-user has to connect via wire and input the IP address of the controller to receive its' config.