Wireless Access

Reply
Occasional Contributor II
Posts: 13
Registered: ‎03-04-2015

Mounting AP-220s and AP-320s to unistrut.

Hi everyone,

 

New to Aruba equipment. Some of my indoor areas the only place to mount the AP is on unistrut. Has anyone done this and which mount did you use? My SE suggesting using the W1 wall mount to accomplish this. This will work but I was curious if there were other ways.

 

Thanks!

MVP
Posts: 1,310
Registered: ‎11-07-2008

Re: Mounting AP-220s and AP-320s to unistrut.

That can work, usually you can find a few ubolts, or make your own (with bolts and plate), to thread through the mount's srew holes over the unistrut. You can also look at the W2 mount, where you secure the mount to the unistrut, and then the AP will snap-loc into the W2 mount.

 

Maybe others have example photos if what they have done.

Jerrod Howard
Sr. Techical Marketing Engineer
Occasional Contributor II
Posts: 13
Registered: ‎03-04-2015

Re: Mounting AP-220s and AP-320s to unistrut.

Awesome thanks for the quick reply. That's what I was looking to confirm.


jhoward wrote:

That can work, usually you can find a few ubolts, or make your own (with bolts and plate), to thread through the mount's srew holes over the unistrut. You can also look at the W2 mount, where you secure the mount to the unistrut, and then the AP will snap-loc into the W2 mount.

 

Maybe others have example photos if what they have done.


 

Search Airheads
Showing results for 
Search instead for 
Did you mean: