Hello All,
I've been struggling with getting snmp informs working with airwave. Airwave shows all devices as up and using snmpv3 for polling and i can manually snmpwalk the controllers in question from the airwave cli. However, all of the controllers are overflowing their trap queue limit and i'm not getting any event type information in airwave. No failed radius authentications, etc. I've defined my snmpv3 user under the inform section of device communication (which i think is hidden away nicely). Any advice is appreciated.
Airwave 7.4
3x 200 controllers running AOS 5.0.4.0
3200 controller running 6.1.2.3
650 controller running 6.1.2.5
Airwave cli returns list of mibs from command, looks to be ok...
snmpwalk 10.0.0.1 -v 3 -a SHA -A XXX -x AES -X XXX -u AMP -l authPriv
Aruba CLI outputs...
(3200) (config) #show running-config | include snmp
snmp-server user "AMP" auth-prot sha XXX priv-prot aes XXX
snmp-server enable trap
snmp-server host 10.0.13.210 version 3 AMP inform engine-id 80001f8880909a614df6bdca udp-port 162
(3200) (config) #show snmp trap-hosts
SNMP TRAP HOSTS
---------------
HOST VERSION SECURITY NAME PORT TYPE TIMEOUT RETRY
---- ------- ------------- ---- ---- ------- -----
10.0.13.210 SNMPv3 AMP 162 Inform 60 3
(3200) (config) #show snmp trap-queue | include Total
Total traps in the queue : 250
Total traps generated on the controller : 82253
#3200