Wireless Access

Reply
Frequent Contributor II
Posts: 266
Registered: ‎03-02-2017

Problems when provisioning CAPs

Hi guys,

After upgrading my controller to 6.5.1.0 I was able to convert two IAPs to CAPs and be managed by the controller. However, I have provisioned successfully my AP 325 to my AP group, it is working properly, but I have problems provisioning my AP 305 to the same group, I don't know the reason. CPSec is disabled. Attached the following screenshots.
Both APs seem to be up
1.PNG

After clicking on number 2 in the Access Points row I get this
2.PNG

If a click on the MAC address of the 305 AP I get this
3.PNG

After a few seconds the AP is down in Monitoring>Network Summary
4.PNG

If a click on the red number 1 in the Access Points row I get this
5.PNG

AP 305 is alternating between up and down. The System Status LED is always in green intermittent state.
I don't know how to troubleshoot this issue or the command to use. Please help.

Regards,
Julián

Guru Elite
Posts: 21,291
Registered: ‎03-29-2007

Re: Problems when provisioning CAPs

Type "show log system 50" on the command line and see if it gives you any clues about that access point.


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: