Wireless Access

Reply
Occasional Contributor II
Posts: 41
Registered: ‎06-06-2013

RAP3 with AP125

Hi All;

 

I'd like to configure a RAP3 as a Virtual Controller, and use two AP125 (one connected in ETH2 and configured as a Mesh Portal, and another as a Mesh Point). I have a small branch office, but I need to use Mesh Points to cover all environment. 

 

This is a possible configuration? Or just using IAP models?

 

Best Regards. 

 

Valter Junior

 

 

 

MVP
Posts: 4,301
Registered: ‎07-20-2011

Re: RAP3 with AP125

[ Edited ]
This scenario won't work for you using a VC , you will need an actual controller to do this with AP125's .

But this could work if you had a couple of dual band IAPs
Thank you

Victor Fabian
Lead Mobility Engineer @ Integration Partners
AMFX | ACMX | ACDX | ACCX | CWAP | CWDP | CWNA
MVP
Posts: 288
Registered: ‎08-27-2012

Re: RAP3 with AP125

The AP125 is a controller managed model. To use Instant and the virtual controller all APs must run instant (either the newer rap models or an IAP). If you need a low cost low density solution you might want to look at the IAP-103 as its list price is 395.
ACDX #419 | ACMP |
Search Airheads
Showing results for 
Search instead for 
Did you mean: