Hello,
I unchecked all the 80mhz channels pairs under the reg domain. This did not work so i enabled them again.
After that i disabled the 80mhz usage under the High-Throughput SSID settings.
At first this also did not have any effect, so i also disabled 80mhz support in the ARM settings for the a and g radio.
That seemed to do the trick!
Where i first got the messages every minute, now i dont see any radar detect messages anymore at all.
Also it looks like instantly the wifi network has gotten a lot more stable.
Thank you for the tips!
Since there is no equipment here yet that uses the 80mhz, i can leave it disabled for now.
Now for future references, is it possible the AP's were detecting each other as radar? And if I enable 80mhz again in the future, are here any other channels/settings I should disable for it to work normally?
Thankyou for your help so far.