Wireless Access

Reply
Occasional Contributor II
Posts: 23
Registered: ‎03-07-2014

Re: SNMP monitoring

my controller is configure as master-standby this works fine

i will enable snmp to solarwinds upon configuration i can only see the ip of the VRRP which is fine, 

 

but i want to see the 2 hardware to be monitored. how to configure this setup to be able to monitor the 2 hardware, thanks

Guru Elite
Posts: 20,821
Registered: ‎03-29-2007

Re: SNMP monitoring

You will have to consult SolarWinds on how to do this.  Each device would need to be monitored by its own specific ip address, NOT the vrrp...



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: