Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Reset to factory default a provisioned access point from controller WebUI or CLI

This thread has been viewed 5 times

  • 1.  Reset to factory default a provisioned access point from controller WebUI or CLI

    Posted May 21, 2014 05:53 AM

    So, simple question.

     

    I just want to reset to factory default an Access Point provisioned and working fine in my controller. Is there any way of remotely reset to factory default an Access Point?

     

    Regards,



  • 2.  RE: Reset to factory default a provisioned access point from controller WebUI or CLI
    Best Answer

    EMPLOYEE
    Posted May 21, 2014 05:56 AM
    You cannot. You'd have to make any changes by reprovisioning it from the
    controller.


  • 3.  RE: Reset to factory default a provisioned access point from controller WebUI or CLI

    MVP
    Posted May 21, 2014 03:20 PM

    You can also default an AP from a connection to its console port by interrupting the boot process

     

    From the "apboot>" prompt, type purgeenv This erases all the configuration settings on the AP.