Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

SSH into Privileged Mode on the CLI

This thread has been viewed 4 times

  • 1.  SSH into Privileged Mode on the CLI

    Posted Mar 14, 2014 03:00 PM

    Hello Everyone,

     

    I am trying to find a way to ssh into privileged mode on the controller CLI (Aruba3600 Version 6.1.3.6) like you can on a Cisco with "privilege level 15" under the line vty.

     

    Is this possible?  What are the commands to use? 

     

     



  • 2.  RE: SSH into Privileged Mode on the CLI
    Best Answer

    EMPLOYEE


  • 3.  RE: SSH into Privileged Mode on the CLI

    Posted Mar 16, 2014 11:55 AM
    @cjoseph wrote:

    That sounds like "Enable Bypass" - http://www.arubanetworks.com/techdocs/ArubaOS_63_Web_Help/Web_Help_Index.htm#ArubaFrameStyles/1CommandList/enable_bypass.htm

    didnt even knew that existed, good one.



  • 4.  RE: SSH into Privileged Mode on the CLI

    Posted Mar 14, 2014 03:44 PM
    There is the global command "enable bypass" but that would enable it for all users.


  • 5.  RE: SSH into Privileged Mode on the CLI

    Posted Mar 15, 2014 03:27 PM
    Once logged in ssh, in the read only mode , use the 'enable' command you'll be prompted to supply your enabled pass word created during setup.


  • 6.  RE: SSH into Privileged Mode on the CLI

    Posted Mar 17, 2014 12:26 PM

    Thank you all for your input.   I was hoping for more of a direct login from ssh into privileged mode instead of disabling 'enable' altogether.  I guess it's not an option. 

     

    Anyway, thank you all  for your input.