Wireless Access

Reply
New Contributor

SSH into Privileged Mode on the CLI

Hello Everyone,

 

I am trying to find a way to ssh into privileged mode on the controller CLI (Aruba3600 Version 6.1.3.6) like you can on a Cisco with "privilege level 15" under the line vty.

 

Is this possible?  What are the commands to use? 

 

 

Guru Elite

Re: SSH into Privileged Mode on the CLI

That sounds like "Enable Bypass" - http://www.arubanetworks.com/techdocs/ArubaOS_63_Web_Help/Web_Help_Index.htm#ArubaFrameStyles/1CommandList/enable_bypass.htm



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

New Contributor

Re: SSH into Privileged Mode on the CLI

There is the global command "enable bypass" but that would enable it for all users.
jt-
Occasional Contributor I

Re: SSH into Privileged Mode on the CLI

Once logged in ssh, in the read only mode , use the 'enable' command you'll be prompted to supply your enabled pass word created during setup.

Re: SSH into Privileged Mode on the CLI


cjoseph wrote:

That sounds like "Enable Bypass" - http://www.arubanetworks.com/techdocs/ArubaOS_63_Web_Help/Web_Help_Index.htm#ArubaFrameStyles/1CommandList/enable_bypass.htm


didnt even knew that existed, good one.

New Contributor

Re: SSH into Privileged Mode on the CLI

Thank you all for your input.   I was hoping for more of a direct login from ssh into privileged mode instead of disabling 'enable' altogether.  I guess it's not an option. 

 

Anyway, thank you all  for your input.

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: