Wireless Access

Reply
Occasional Contributor II
Posts: 58
Registered: ‎05-22-2016

Show NAT/PAT table

Hi guys, is there a way to see the NAT/PAT table, probably the answer is show datapath session table but is there a good way to just show how many internal users are PAT to my external IP address, lets say users comming from a 172.24.0.0/24 network and going to 1.1.1.1 adress (1.1.1.1 in this example is my public routable address)

MVP
Posts: 1,408
Registered: ‎05-28-2008

Re: Show NAT/PAT table

From AirHeads:

https://community.arubanetworks.com/t5/Controller-Based-WLANs/How-do-I-check-whether-the-NAT-translations-are-active/ta-p/180930

 

How do I check whether the NAT translations are active?

Product and Software: This article applies to all Aruba controllers and ArubaOS versions.

For the global NAT table:

(Aruba) #show datapath nat table

Datapath NAT Table Entries

--------------------------

Pool SIP Start SIP End DIP

---- --------------- --------------- ---------------

0 10.13.106.255 10.13.106.255 10.13.106.255

For the specific AP:

(Aruba3200) #show datapath nat ap-name Sam-AP125

Datapath NAT Table Entries

--------------------------

Pool SIP Start SIP End DIP

---- --------------- --------------- ---------------

0 172.16.0.253 172.16.0.253 172.16.0.253

*****************2Plus Wireless Solutions****************************
Aruba Airheads - Powered By community for empower the community
************ Don't Forget to Kudos + me,If i helped you******************
Occasional Contributor II
Posts: 58
Registered: ‎05-22-2016

Re: Show NAT/PAT table

Hi, ok, but how can i check how many ports am i using out of the 65535 ephemeral ports. I am having a weird issue were traffic seems to stop working for a couple of seconds/minutes and it might be i am port address translating all my addresses to 1 "external" address. Just want to be able to confirm it.

Search Airheads
Showing results for 
Search instead for 
Did you mean: