Wireless Access

Reply
Frequent Contributor II
Posts: 159
Registered: ‎12-06-2010

Site to Site w/ Dynamic IP - Design & Advice

I realize that site-to-site VPN is possible with one controller having a dynamic IP, however I'm looking for any advice or recommendations on how I might chose a controller and/or configure this before ordering equipment.

 

My scenario is this: Site A has an existing 620 local running 6.1.3.6-Airgroup & Site B has a 620 master running the same AOS. I will be implementing some new AP's at site A which are not compatible with AOS 6.1.X so I'm looking at using a new 7005 running 6.4 code. Site A does NOT have a static public IP while site B DOES. My plan is to make the 7005 at site A a standalone master & then create a site-to-site VPN back to site B's master. This would allow for the same type of L3 routing that we already have with the master-local IPSEC tunnels.

 

I'm open to any thoughts, suggestions. Thanks in advance.

Network Engineer | Airhead | Titus 3:5
Frequent Contributor II
Posts: 159
Registered: ‎12-06-2010

Re: Site to Site w/ Dynamic IP - Design & Advice

Bump. Any thoughts or suggestions?

Network Engineer | Airhead | Titus 3:5
Guru Elite
Posts: 20,990
Registered: ‎03-29-2007

Re: Site to Site w/ Dynamic IP - Design & Advice

Clayman,

 

Is your question about if you should use the 7005 to terminate a site to site VPN using dynamic ip addresses?

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Frequent Contributor II
Posts: 159
Registered: ‎12-06-2010

Re: Site to Site w/ Dynamic IP - Design & Advice

My question is, does anyone see any reason why this would not work or if there are any "gotcha's" with tryin to do a site-to-site between a 7005 & a 620. The 7005 would have a dynamic public IP while the 620 would be static.

Network Engineer | Airhead | Titus 3:5
Search Airheads
Showing results for 
Search instead for 
Did you mean: