Wireless Access

Reply
New Contributor
Posts: 2
Registered: ‎10-16-2013

Static IP address set-up on AP-135

Cana static IP address be manually configured on an AP-135 using the ETH0 port? DHCP is not available.  The AP-135s are deployed and cabled back to a communications room.  Come to find out that the switch that they will connect to is on a network that does not support DHCP.  Do I have to connect to the console port for console access (which means going to each AP location)?

Aruba
Posts: 1,377
Registered: ‎12-12-2011

Re: Static IP address set-up on AP-135

Yes...you would need to connect to the console if the AP didn't get a DHCP address.  Another way would be to connect the AP temporarily to a user VLAN with DHCP...once provisioned to the controller, re-provision it and set the IP address in the provisioning screen.  It will reboot with that IP address.  You will then move it back to that original VLAN and everything should work.

Seth R. Fiermonti
Consulting Systems Engineer - ACCX, ACDX, ACMX
Email: seth@hpe.com
-----
If you found my post helpful, please give kudos
Guru Elite
Posts: 8,633
Registered: ‎09-08-2010

Re: Static IP address set-up on AP-135

At the AP console:

 

setenv ipaddr x.x.x.x
setenv netmask x.x.x.x
setenv gatewayip x.x.x.x

saveenv

boot


Tim Cappalli | Aruba Security TME
@timcappalli | timcappalli.me | ACMX #367 / ACCX #480
New Contributor
Posts: 2
Registered: ‎10-16-2013

Re: Static IP address set-up on AP-135

Thanks for the quick response!

Search Airheads
Showing results for 
Search instead for 
Did you mean: