Wireless Access

Reply
Occasional Contributor II

UPDATE REQUIRED(Master Unreachable)

Hello Everybody,

 

I have two Aruba 7210 controllers one is master and one is standby, few days ago the master controller had hardware failure. so i am replacing the master with new master, i did the VRRP, LMS and redundancy configuration but i get this error UPDATE REQUIRED(Master Unreachable) at the monitoring controller section. 

I read that both of controllers should be in the same VLAN, but i cannot do this because the other controller is in production and it is configured as Trunk. 

 

Any thoughts?

 

Thanks,

Mahmoud

Guru Elite

Re: UPDATE REQUIRED(Master Unreachable)

The master redundancy peer-ip command has a preshared key that you need to enter that matches the standby  http://www.arubanetworks.com/techdocs/ArubaOS_64x_WebHelp/Web_Help_Index.htm#ArubaFrameStyles/1CommandList/master_redundancy_peer_i.htm?Highlight=master redundancy



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor II

Re: UPDATE REQUIRED(Master Unreachable)

this is the configuration i have for this part, so this command was used. and still the problem exist.

 

master-redundancy
master-vrrp 22
peer-ip-address 10.27.22.12 ipsec 925e0e072a5160a4042926137d418c82f82b89d0b1

 

I can ping both of controllers from my core switch but the controllers don't ping each other.

 

Thanks,

 

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: