Hi, Im have been trying to upgrade my 3400 wireless controller and followed the necessary documentation to upgrade the AOS from my PC.
cpboot>setenv ipaddr x.x.x.x
cpboot>setenv netmask x.x.x.x
cpboot>setenv gatewayip x.x.x.x
cpboot>setenv serverip x.x.x.x (note: if you are running the tftp program on the same PC then the gatewayip and serverip should be same)
==============================================================================
Output:
=======
cpboot> ver
CPBoot 1.3.0.1 (build 34416)
Built: 2012-07-09 at 23:41:03
cpboot> printenv
bootargs=quiet
bootcmd=bootf
bootdelay=5
baudrate=9600
loadaddr=0x87000000
psb_os_cpu_mask=0
ethaddr=00:0b:86:99:44:44
ipaddr=10.1.1.1 <= Controller ip
netmask=255.255.255.0
gatewayip=10.1.1.2 <= PC IP
serverip=10.1.1.2 <= PC IP
ethact=xlr_gmac3
Environment size: 211/131068 bytes
cpboot>
cpboot> ping 10.1.1.2
Using xlr_gmac3 device
host 10.1.1.2 is alive
cpboot> upgrade 1 ArubaOS_MMC_6.4.2.8_50314
0: Device not present
Invalid upgrade device: 0
cpboot> upgrade 0 ArubaOS_MMC_6.4.2.8_50314
0: Device not present
Invalid upgrade device: 0
How do i know which partition is present, i have tried 0, 1, 0:0, 0:1 . Is there a command to check the flash or if the disk are present.
Any Workarounds that i can try ???
=================================================
The following is the displayed boot information
-----------------------------------------------------------------
System will be rebooted in about 1 seconds..
CPBoot 1.3.0.1 (build 34416)
Built: 2012-07-09 at 23:41:03
DRAM: Operating at 533 MHz
DRAM: Channel 0: 512 MB
DRAM: Channel 2: 512 MB
DRAM: Total = 1024 MB
POST: Memory test: Physical 0x00000000 - 0x10000000 - quick test
Memory test: Physical 0x10000000 - 0x40000000 - quick test
PASS
CPU: XLR516 rev. C4 Clock: 800MHz
Board: A3400
CPLD: rev: 1.3
SMP: All 16 cpus successfully started
Boot: Primary bootflash partition
POST2: OK
Net: xlr_gmac0 xlr_gmac1 xlr_gmac2 xlr_gmac3
IDE: Bus 0: Bus 0: not available
Hit any key to stop autoboot: 0
cpboot>
cpboot>