Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

[Urgent] APs 105 not working with Etherent port 10 mb

This thread has been viewed 1 times

  • 1.  [Urgent] APs 105 not working with Etherent port 10 mb

    Posted Dec 31, 2014 05:28 AM

    dear all,

    i found  some truble when using old cisco catalyst switch 1900 serie with Aruba AP 105 , we can't detect the AP from the controlleur.

    I susspect the switch speed 10 MB ,

    any suggestion ?

    Regards



  • 2.  RE: [Urgent] APs 105 not working with Etherent port 10 mb
    Best Answer

    Posted Dec 31, 2014 05:44 AM
      |   view attached

    as already mentioned the problem is in the port speed on the datasheet they clearly say that the AP 105 work with the switch 100/1000 BASE-T

     

     



  • 3.  RE: [Urgent] APs 105 not working with Etherent port 10 mb

    Posted Jan 01, 2015 02:19 AM
    Might also want to check the power if this is a Poe switch. You'll need 802.3af.


  • 4.  RE: [Urgent] APs 105 not working with Etherent port 10 mb

    Posted Jan 01, 2015 01:42 PM
    Now that I read the spec sheet rchahboune is most definitely correct. If you're not using both 10/100 ports you could try using one of those, but other than that I would honestly invest in some newer switch hardware.