Wireless Access

Reply
Occasional Contributor II
Posts: 21
Registered: ‎04-13-2009

VIA Default Route

I think i know the answer...   I have VIA working on a l3 network, and a network that isn't l3, but I have a route too to the Aruba controller... my question is this.

 

Controller is in DMZ...  default route on controller is the FW.  I have explicit routes on the controller pointing back to the Core Infrastructure.    Via connects fine, I can ping connect whatever to internal resources... my question is this...since there is a default route, pointing the the firewall, when via wants to browse the internet it uses this route....

 

Is there anyway to change this?  

 

(USER didn't want to nat something to the "internal" network"..)  again the answer is no, i'm 99.5% sure there isn't a way to do this but just wondering if I missed something in the VRD's..

 

 

Guru Elite
Posts: 21,491
Registered: ‎03-29-2007

Re: VIA Default Route

Would you prefer to have it just simply go out a different gateway or would you instead want to exercise the "split tunnel" feature?

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Occasional Contributor II
Posts: 21
Registered: ‎04-13-2009

Re: VIA Default Route

Different gateway.
Guru Elite
Posts: 21,491
Registered: ‎03-29-2007

Re: VIA Default Route

Ah.

 

I do not think that is possible.

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: