Wireless Access

Reply
Occasional Contributor II
Posts: 14
Registered: ‎01-06-2012

VIA connects but I can't send any traffic.

[ Edited ]

I found another document at http://www.arubanetworks.com/wp-content/uploads/VIAAppNote.pdf that gave me some of my answers so I'm editing this post.

 

1. I'm setting up my WLAN profile under Configuration-> Advanced Services->  All Profile Management -> Wireless LAN -> VIA Client WLAN Profile rather than Configuration > Advanced Services > All Profiles as I don't have that option.  My controller is running 6.1.3.2. Am I setting it up in the wrong place?

 

2. I'm not pushing the WLAN out to any of my access points.  Should I be?  Do I need to check the "Connect even if this WLAN is not broadcasting" box in my WLAN profile?

 

3. My biggest issue is that I can't send/receive traffic.  I setup an interface on my controller to an internal subnet I wasn't using 172.16.2.0/24.  I gave the controller's interface 172.16.2.253 and the interface on my firewall is 172.16.2.254.  I'm then giving out IP addresses 172.16.2.1 - 172.16.2.250 for my VIA clients.  I have source nat turned off and enable-inter vlan routing turned on.  Could I have these wrong?

 

Any assistance would be greatly appreciated.

 

Search Airheads
Showing results for 
Search instead for 
Did you mean: