Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Verification of client association status behind "client bridges"

This thread has been viewed 0 times

  • 1.  Verification of client association status behind "client bridges"

    Posted Mar 06, 2017 09:05 AM

    Hi,

     

    How is it in Aruba that we obtain the statuses/ip addresses of "wired client" that are sitting behind the client bridges in Aruba?

    The client bridge that is connected on to the Aruba WLAN is the third party Access Point, configured in client bridge mode.



  • 2.  RE: Verification of client association status behind "client bridges"

    Posted Mar 06, 2017 07:29 PM

    Hi,

     

    Wired users would not come up in user-table of controller unless they come from an untrusted soruce.

     

    Also, I believe since it is bridge, users behind the bridge would come up with same MAC address as the bridge device in User table.

     

    Command to check user information;

     

    #show user-table 

    #show user <client IP>



  • 3.  RE: Verification of client association status behind "client bridges"

    Posted Mar 08, 2017 03:17 AM

    Hi Adnan,

     

    From DHCP perspective, you can use the following command

     

    show datapath dhcp vm-mac