Wireless Access

last person joined: yesterday 

Access network design for branch, remote, outdoor, and campus locations with HPE Aruba Networking access points and mobility controllers.
Back to discussions
Expand all | Collapse all

Verify Link Aggregation on Controller

This thread has been viewed 0 times

  • 1.  Verify Link Aggregation on Controller

    Posted Jun 14, 2017 12:05 AM

    I had already configured the controller for 3x10G, and How to verify that the port-channel are using 30G bw? on the controller side.



  • 2.  RE: Verify Link Aggregation on Controller

    EMPLOYEE
    Posted Jun 14, 2017 06:11 AM

    What kind of Link Aggregation are you using?

    What is your configuration?

    What is the switch manufacturer an what commands are you using for link aggregation?



  • 3.  RE: Verify Link Aggregation on Controller

    Posted Jun 14, 2017 09:06 AM

    Hi  cjoseph

     

    LACP

    Mode Active

    Cisco Switch (switchport mode trunk, port-channel group 0, port-channel protocol lacp)



  • 4.  RE: Verify Link Aggregation on Controller

    EMPLOYEE


  • 5.  RE: Verify Link Aggregation on Controller

    Posted Jun 14, 2017 09:45 AM

    Thanks, I'd already read this topic, and How to show BW like this on the controller? (Capture from command of cisco switch)

     

    Ex : "BW 3000000 Kbit"

    cisco-side.PNG



  • 6.  RE: Verify Link Aggregation on Controller
    Best Answer

    EMPLOYEE
    Posted Jun 14, 2017 10:12 AM

    There is no command that shows you the bandwidth.  The show interface port channel command does tell you what interfaces are bonded, however...  http://www.arubanetworks.com/techdocs/ArubaOS_65x_WebHelp/Web_Help_Index.htm#ArubaFrameStyles/1CommandList/show_interface_port_chan.htm?Highlight=show interface