Wireless Access

Reply

WMS Database is disabled?

Trying to manually contain a rogue the following way

 

wms ap <mac> mode manually-contain

 

and I get the following error message

"Database is disabled. Command not allowed"

 

I have never seen this.

WMS Offload is enabled and I have Airwave, I would like to disable it but when I remove WMS offload from Airwave, it does not push the commands to the controller.

Pasquale Monardo | Senior Network Solutions Consultant
ACDX #420 | ACMP
[If you found my post helpful, please give kudos!]
Guru Elite

Re: WMS Database is disabled?


pmonardo wrote:

Trying to manually contain a rogue the following way

 

wms ap <mac> mode manually-contain

 

and I get the following error message

"Database is disabled. Command not allowed"

 

I have never seen this.

WMS Offload is enabled and I have Airwave, I would like to disable it but when I remove WMS offload from Airwave, it does not push the commands to the controller.


You cannot run WMS commands if Airwave is doing the offload.  You should be able to change the "Offload WMS Database" to no to disable to offload.  If that does not work, please contact support.

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Re: WMS Database is disabled?

That is what I thought since WMS offload is enabled, that Airwave is now the mobility-manager.

Tried disabling but looking at the audit-trail I do not see any commands being pushed to the controller

 

I am wondering whether I can just go and remove the mobility-manager from the controller.

If not, TAC it is.

Pasquale Monardo | Senior Network Solutions Consultant
ACDX #420 | ACMP
[If you found my post helpful, please give kudos!]
Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: