Wireless Access

Reply
Aruba Employee

Why 'I' Flag appears in ap database when the AP is terminating on the Local in a Master-Local Setup

Hi,

 

I have a Master-Local Setup . And I need the AP to terminate on the Local Controller and so am Provinding the LMS as the local controller and Backup LMS as the Master Controller. When I bring up the AP, in Show AP database command the 'I' flag is set when am viewing from the Local Controller but when am viewing from Master Controller , no flags are set. What could be the reason for this ??

Guru Elite

Re: Why 'I' Flag appears in ap database when the AP is terminating on the Local in a Master-Local Se

Probably because the Virtual AP the AP is in is referencing a VLAN that does not exist on your local controller.  Vlans have to be created locally on each controller and are not synched with the global config.



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
cancel
Showing results for 
Search instead for 
Did you mean: