Wireless Access

Reply
Occasional Contributor II
Posts: 14
Registered: ‎01-16-2013

Without Controller how to make AP-93shall broadcast SSID ?

Hey  ,  I Urgently need Access-point which will broadcast the ssid without controller .

 

Advance thanks for your comment.

Aruba
Posts: 1,644
Registered: ‎04-13-2009

Re: Without Controller how to make AP-93shall broadcast SSID ?

This is only possible with Instant APs (model numbers that begin with IAP-).    For example, IAP-93, not AP-93.

 

 

------------------------------------------------
Systems Engineer, Northeast USA
ACCX | ACDX | ACMX

Frequent Contributor II
Posts: 113
Registered: ‎11-27-2012

Re: Without Controller how to make AP-93shall broadcast SSID ?

To expand on clembo's answer, you can find more information about the Instant AP products here: 

 

http://www.arubanetworks.com/products/instant-access-points

 

This page will tell you what IAP's are available and tell you about their features.

The IAP models are the same as the standard AP's but with different firmware, so they look the same and have the same features.

Just remember, like clembo said. the model numbers must begin with IAP, not AP :)

-----------------------------------
-ACMX #352-
Remember to Kudo if a post helped you! || Problem Solved? Click "Accept as Solution" in a post!
MVP
Posts: 1,437
Registered: ‎10-25-2011

Re: Without Controller how to make AP-93shall broadcast SSID ?

Instant is the way to go but without knowing your particular use-case there is the following.

 

RAP's in Bridge mode have a setting where you can broadcast the SSID Always even if the tunnel is down but as long as the AP has power it will broadcast.

Pasquale Monardo | Senior Network Solutions Consultant
ACDX #420 | ACMP
[If you found my post helpful, please give kudos!]
Search Airheads
Showing results for 
Search instead for 
Did you mean: