Wireless Access

Reply
Occasional Contributor II
Posts: 19
Registered: ‎07-24-2014

can bridging support high traffic ?

i have 2 data center and need to be connected together ,

so if i connect them by outdoor AP like AP-275 ,

what is the max data rate TX/RX ?

can bridging support  high data rate traffic ?

 

notice that :

2 building are LOS and distance is about 100 meter .

the 2 data center have alot of traffic .

 

please advice

 

thanks ,

Best Regards,

 

Ehab Atef

Network Engineer

 

MVP
Posts: 288
Registered: ‎08-27-2012

Re: can bridging support high traffic ?

Mesh isn't currently supported on AC APs. It should be coming soon. Once it does I would look at an AP-274 with high gain directional for backhaul.
ACDX #419 | ACMP |
Guru Elite
Posts: 21,272
Registered: ‎03-29-2007

Re: can bridging support high traffic ?

Sustaining high throughput 802.11ac with mesh  would require very close (less than 9  meters) proximity between transmit and receiver to sustain the highest rates, just like it does with clients.  It is even more difficult trying to implementing this outdoors due to the increased interference.  I would not even think about doing wireless between datacenters...

 

 

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

MVP
Posts: 288
Registered: ‎08-27-2012

Re: can bridging support high traffic ?

For only 100m you might consider talking to a cabling service about fiber. That's a pretty short run, and you could sustain much better throughout.
ACDX #419 | ACMP |
Search Airheads
Showing results for 
Search instead for 
Did you mean: