@mate78 wrote:
I have set up Fast Failover where one controller is active and one is standby. I also have provisioning where all APs are assigned with static IP and master discovery policy is set to Master Controller IP Address with IP address of active controller. Is that configuration good enough to work with Fast Failover?
The static IP assignment is fine, but DHCP would be preferred. What do you mean you're "discovery policy is set to master controller IP address with IP address of active controller"? Do you have a master and two locals (1 active, the other standby)? Or are you using your master to terminate APs and function as the active controller?
@mate78 wrote:
LMS IP of AP system profile should have IP od active controller? Should I also set backup LMS IP to standby controller?
Does Fast Failover work with AP bridge mode?
Is there any command that can verify if APs are connected to both controllers because network summary on active controller displays all 30 APs but standby only 20?
LMS IP should be that of the active controller.
Do not set a backup LMS IP. In the HA profile you will configure your active/standby controllers.
Fast failover is not compatible with bridge mode. Only tunnel mode is supported.
Here is a link to the the 6.3 user guide that explains step-by-step how to configure fast failover.