Wireless Access

Reply
Contributor I
Posts: 71
Registered: ‎12-14-2011

cli command to show power on second port of Ap225

HI,

 

We are deploying a AP225 as a RAP, wireless all looks fine but when we connect a further connection to the second ethernet port we are not able to see any led active on it. We want to send these off to different places and want to be able to do a command to see if the AP doesnt have sufficient PoE to power it so we can advise accordingly. We have been successful with one or two switches, I am guess that the switch needs PoE+? Not sure of the officilal requirement for the second port. Any ideas on both? Thanks!

Guru Elite
Posts: 21,293
Registered: ‎03-29-2007

Re: cli command to show power on second port of Ap225

You need POE+ on a single port for the second ethernet port to work.



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Contributor I
Posts: 71
Registered: ‎12-14-2011

Re: cli command to show power on second port of Ap225

Thanks for configrming its PoE+ cjoseph but is there a copmmand to see what power (poE) its receiving?

Guru Elite
Posts: 21,293
Registered: ‎03-29-2007

Re: cli command to show power on second port of Ap225

show ap debug system-status ap-name <name of ap> | begin "Power Status"

 

The output should look like this:

 

Power Status
------------
Operational State          POE-AT: No restrictions
-----------------          -----------------------
Current HW State           POE-AT: No restrictions


Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Contributor I
Posts: 71
Registered: ‎12-14-2011

Re: cli command to show power on second port of Ap225

Thanks, I am getting this on a CAP AP225:- Can you explain how we know this is getting enough power for second port. Not sure what refers to whether it has PoE+ as opposed to PoE?

Power Status
------------
Operational State          POE-AT: No restrictions
-----------------          -----------------------
Current HW State           POE-AT: No restrictions
LLDP Negotiated POE Power  13.0W

Bandwidth Contracts Information
-------------------------------
Received BWM Config:
--------------------
--------------------
        ACL                                                            DIR  Contract-ID PerUser UseCount Rate

Allocated Contracts:
--------------------
Contract-ID Rate       UseCount Available-Bytes Max-Bytes Policed-Bytes

 

Guru Elite
Posts: 21,293
Registered: ‎03-29-2007

Re: cli command to show power on second port of Ap225

Operational State          POE-AT: No restrictions
-----------------          -----------------------
Current HW State           POE-AT: No restrictions

 

This is all you need.

 



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Guru Elite
Posts: 21,293
Registered: ‎03-29-2007

Re: cli command to show power on second port of Ap225

To be clear, "Operational State" is the end-result



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Contributor I
Posts: 71
Registered: ‎12-14-2011

Re: cli command to show power on second port of Ap225

Thanks again cjoseph. Got it.

Search Airheads
Showing results for 
Search instead for 
Did you mean: