Wireless Access

Reply
Occasional Contributor II
Posts: 60
Registered: ‎07-07-2016

gre tunnel

below is the configuration i have done in two controllers 192.168.29.156 and 192.168.29.159 and created vlan 90 in both controllers and given vlan ip as 192.168.150.159 and 192.168.150.156 in  29.159 and 29. 156 respectively . but its not pinging to 192.168.150.159 from 192.168.150.156 and vice versa

 

#interface tunnel 18

(DMZ) (config-tunnel)#tunnel mode gre 1
(DMZ) (config-tunnel)#tunnel source vlan 150
(DMZ) (config-tunnel)#tunnel destination 192.168.150.159
(DMZ) (config-tunnel)#tunnel keepalive
(DMZ) (config-tunnel)#trusted
(DMZ) (config-tunnel)#tunnel vlan 90
(Master) (config-tunnel)#no sh
(Master) (config-tunnel)#write me


#interface tunnel 12
(Master) (config-tunnel)#tunnel mode gre 1
(Master) (config-tunnel)#tunnel source vlan 150
(Master) (config-tunnel)#tunnel destination 192.168.150.156
(Master) (config-tunnel)#tunnel keepalive
(Master) (config-tunnel)#trusted
(Master) (config-tunnel)#tunnel vlan 90
(Master) (config-tunnel)#no sh
(Master) (config-tunnel)#write me

 

Regards, 

Mallikarjun

Guru Elite
Posts: 21,491
Registered: ‎03-29-2007

Re: gre tunnel

Type "show ip route" on each controller to see what route it is taking to each ip address that you want to ping.

 

Could you ping those ip addresses before you established the tunnels?



Colin Joseph
Aruba Customer Engineering

Looking for an Answer? Search the Community Knowledge Base Here: Community Knowledge Base

Search Airheads
Showing results for 
Search instead for 
Did you mean: